Code Mercenaries' USB to DALI bridge is mounted on DIN rail to support lighting control

April 8, 2016
Code Mercenaries introduces LED-Warrior14U-DR, a USB to DALI bridge. LED-Warrior14U-DR is mounted on a DIN rail. It can send and receive all 16 bit DALI commands and receive 8 bit replies. Power is supplied via USB and the DALI bus is galvanically isolated.

A library that allows execution of DALI commands and coding examples are available for application support. The USB interface uses a Code Mercenaries IO-Warrior24. Several tools and much support on various platforms is available for the IO-Warrior chip family. Installing a specific driver is not required, IO-Warrior24 is supported by system drivers on almost all operating systems.
LED-Warrior14U-DR was introduced on the light+building 2016 show in Frankfurt. It will become available in May.

Technical Data
• USB to DALI bridge
• Supports all 16 bit forward telegrams
• Receives all 16 bit forward telegrams of other masters on the same bus
• Receives all 8 bit reply telegrams
• Power supply via USB
• Galvanical isolation between USB and DALI
• Mounting on a DIN rail
• USB connection with IO-Warrior24
• No driver installation necessary

DALI is a registered trade mark of ZVEI


Doreen Hessenmöller, Marketing - Code Mercenaries Hard- und Software GmbH