Code Mercenaries will demonstrate its LED-Warrior10 PWM LED dimmer at Light+Building

LED-Warrior10 allows solid-state lighting system designers to control LED brightness by a potentiometer, or one or two buttons. The high pulsewidth modulation (PWM) frequency of 730 Hz guarantees flicker free
operation. For button control a power-on value and minimum value may be set.
The LED-Warrior10 LED dimmer is available as a DIL8 or SOIC8 chip or as a ready-to-use module. The module (LW10-01MOD) can control LED drivers which have a PWM input or it can directly supply constant voltage LEDs with up to 4 A. LED strips, lamps, or modules working with a constant voltage in the range of 5.5 V to 40 V can be directly driven.

A potentiometer may be soldered direct into the module. The LED dimmer is available as a chip or module.

TECHNICAL DATA
• PWM dimmer for LED
• Dimming control by single or dual button or by potentiometer
• Power-on brightness programmable
• Minimum brightness programmable
• Logarithmic curve for optimal dimming
• PWM output at 730 Hz
• PWM dimming from 0.1 % to 100 %
• PWM power output up to 4 A
• Available as module or DIL8/SOIC8 chip

(The potentiometer is not part of the product.)
Visit us at the Light and Building Frankfurt in hall 4.0 booth G06.

Contact:

Code Mercenaries Hard- und Software GmbH
+49-3379-2050-9-20

Locate more driver & controls vendors in the LEDs Magazine Suppliers Directory

Submit new products, case studies/projects, and other press releases at http://www.ledsmagazine.com/content/leds/en/addcontent.html.

More from Code Mercenaries:
Code Mercenaries engineers DALI controller with PWM and I2C signal capabilities for intelligent lighting

More in LEDs & SSL Design